Instruction Manual Transmitter DTS-3 Receiver DRS-3
Sel/Ch button +/- button LED Indicator Steering wheel Th D/R button ST D/R button Power switch Throttle trim Throttle trigger Grip handle Battery box Steering trim DTS-3 The Dragon DTS-3 transmitter is an advanced 2.4 gHz radio-system with clear settings which are easy to tune. The transmitter is pre-tested, checked for proper functioning, and pre-set with default, to operate the car. In case you want to change any setting then follow the instruction in the manual.
INSTALL THE BATTERIES 1) Remove the battery cover carefully. 2) Place 4 x AA size batteries inside, check the right + and - position. Please replace or re-charge batteries when the power indicator blinks or buzzer beeps. TRANSMITTER ADJUSTMENT A. Throttle trigger 1) Push the trigger forward to slow down or brake. 2) Pull the trigger backward to accelerate. B. STEERING WHEEL Neutral - Left - Right Turn the steering wheel to the left or right to let the car turn left or right.
OPERATING PROCEDURE Transmitter DTS-3 #210013 Receiver DRS-3 #210014 Before operation: 1) Connect the battery 2) Turn on the transmitter 3) Turn on the receiver After operation: 1) Turn of the receiver 2) Turn off the radio 3) Disconnect the battery cables 1 1 Connect the receiver to the power source and then connect the Bind Connector to the ‘pair’ pin header on the side of the receiver. The LED-light on the receiver should start flashing rapidly.