Dragon-RC DTS-3 Transmitter - Manual

Dragon-RC transmitter-set #210013/14

www.dragon-rc.com - Accessories for radio controlled cars - Dragon-RC is a registered brandname.

FAIL SAFE FUNCTION SETTING

Turn on the transmitter and receiver. Insert the Bind Connector (included with the radio-

set) to fail safe position on receiver as in the diagram. Red LED-light ashes twice and

becomes solid. Setting is successful. Remove the pin header after setting before use.

OPERATING PROCEDURE

Before operation: After operation:

1) Connect the battery 1) Turn of the receiver

2) Turn on the transmitter 2) Turn off the radio

3) Turn on the receiver 3) Disconnect the battery cables

BINDING THE TRANSMITTER AND RECEIVER

1 Connect the receiver to the power source and then connect

the Bind Connector to the ‘pair’ pin header on the side of the receiver.

The LED-light on the receiver should start ashing rapidly.

2 Switch on the transmitter, and then pull the Bind Connector

out of the receiver.

3 The LED-light on the receiver should become solid.

Binding of the transmitter and receiver is then successful.

If not then repeat the above steps carefully.

4 Store the Bind Connector carefully for future use.

Transmitter DTS-3 #210013

Receiver DRS-3 #210014