SRX8 RTR Nitro Buggy - Manual
sAfeTy mATTeRs
All instructions in this manual must be followed to ensure safe use of the car. This model is not
intended for use by children under 14 years .
Important pre-cautions
● Only run the car is designated areas or areas with very few people, so no-one can get hurt.
● The car has a lot of power and the turning parts on the car can cause damage, also some
parts of the car like transmisison and motorparts can become very hot. So wear protective
clothing both as driver and helper and be carefull when picking up the car.
● Do not operate the car under dark conditions, as both you and others may not see the car
properly and can get hurt, due to lack of car control.
● Use good common sense while operating the car so you can fully enjoy your car.
Battery and battery-charging
● The battery and battery-charger are not included with this model. For the transmitter you
need 4 pcs AA size NIMH batteries and for the car you need a NIMH or Lipo battery with a
capacity of 1600 mA or more.
● Use proper battery-charger specically designed for that type batteries and follow the
instructions of the battery supplier and the charger correctly.
● Keep the battery and charger always in dry places only and never leave un-attended during
charging.
● When the batteries are at their end of life, dispose them at a recycling-place, check www.
call2recycle.org for more info.
QUICk-sTART
The quick-start section is not a replacement for the full instructions. To be able to use the model
to its best take the time to read the full manual.
1. Read the manual and safety pre-cautions.
2. Buy and install the batteries in the transmitter ( see Transmitter manual). Install the
RX=receiver battery pack (not included) in the battery-box and connect as shown in the
manual.
3. Turn on the transmitter (see Transmitter manual). Always turn on the transmitter rst
before switching on the car and only turn off the transmitter after you switch off the car.
Put purpose made model car fuel in the fuel tank. Start and run in the engine, as described
in the seperate engine manual.
4. Check servo operation. Check that the servo works correctly and check that the car runs
straight in neutral position, trim as needed.
5. Perform a range test with the radio system.
6. Personalise the body of your car by applying more decals if required.
7. Drive your model car.
8. Maintain your modelcar (page 8).