DragonRC 2.4GHz Transmitter Manual

ST: D/R
11
REVERSE 5.0V
REV
NOR
ST TH AUX
2.7 REV
2.8 ST-CURV
This function reverses the direction of operation of the
servos related to transmitter steering, throttle, and chan-
nel 3 operation.
1. Press ’Roller’ to see FUNCTION MENU.
2. Use the roller to choose REVERSE, and press ’Roller’
to enter REVERSE adjusting interface.
3. Press ‘Roller’ to choose each Channel.
4. Use the roller to change to the desired servo direction
‘REV’ or ‘NOR’.
5. Press ‘Back’ again to return to save your setting and
leave REVERSE interface,and back to the function
menu interface.
Note: However, when the position set by trim or sub trim
shifts from the center, the center becomes the
opposite side.
TERMS: ST-STEERING, TH-THROTTLE,
AUX-AUXILLIARY REVERSE
ST EXP 5.0V ST EXP 5.0V
M: EXP
R: 0%
M: EXP
R: 50%
Function 5.0V
1: EPA
2: D/R
3: S-TRIM
4: REV
5: ST CURV
This function is used to change the sensitivity of the steering servo around the neutral
position. It has no effect on the maximum servo travel.
Note: When the setting is not determined, or the characteristics of the model are
unknown, start with 0% (when EXP is set to 0%, servo movement is linear)
1. Press ‘Roller’ to see FUNCTION MENU.
2. Use the roller to select the ST CURV function and press ENTER.
3. Rotate the roller to change the value.
4. Press ‘Back’ again to return to save and return to FUNCTION MENU, press ‘Back’
again to return to the Main Screen. STEERING CURVE adjusting value range:
-100%~+100%. Default is 0% (Linear) Steering EXP adjustment.
1. Rotate the roller to change to the desired rate value. A positive Expo value increases
the sensitivity around the center while a negative value decreases the sensitivity.
2. When ending setting, return to the function menu by pressing ‘Back’.
TERMS: M-MODE, R-RATE