DragonRC 2.4GHz Transmitter Manual

ABS 10.2V
PT: 10% WD: 50
CY: 15% DL: 0
SM: 0 DT: 1
MODE: INH
2.10 ABS
Without ABS With ABS
2.11 ABS - Anti-Lock Brake System
When the brakes are applied while cornering with a 4-Wheel Drive or other type of
vehicle, under-steer may occur. The generation o funder-steer can be eliminated
and corners can be smoothly cleared by using this function.
- When the brakes are applied, the throttle servo will pulse intermittently.
This will have the same effect as pumping the brakes in a full size car.
- The brake return amount, pulse cycle, and brake duty can be adjusted.
- The region over which the ABS is effective can be set according to
the steering operation.
1. Press ‘Roller’ to see FUNCTION MENU
2. Use the roller to select the ABS function and press ENTER.
3. Press ‘Roller’ to select PT item. Use roller change the value. Range: 0%~100%.
4. Press ‘Roller’ to select WD item. Useto change the value. Range: 0%~100%.
5. Press ‘Roller’ to select CY item. Use roller to change the value. Range: 0~30.
6. Press ‘Roller’ to select DL item. Use roller to change the value. Range: 0~100.
7. Press ‘Roller’ to select DT item. Use roller tochange the value. Range: 0~100%.
8. Press ‘Roller’ to select SM item. Use roller to change the value. Range: 0~100%.
If this value is 0, disable the steering mix.
9. Press ‘Roller’ to select MODE item. Use roller to change INH, TH, AUX or TH, AUX.
10. Press ‘BACK’ again to return to FUNCTION MENU, press ‘BACK’ again to return
to the Main Screen.
TERMS: PT-Operation Throttle Trigger point.
WD-Brake return amount, sets the rate at which the servo returns versus trigger operation
for brake release. When set to 0%, the ABS function is not performed.
CY-Cycle speed. The smaller of the set value, the faster the pulse cycle.
DL-Delay amount. Sets the delay from brake operation to ABS operation. When set to 0%,
the ABSfunction is activated without any delay.
SM-Steering Mix.
DT-Cycle duty ratio, sets the proportion of the time of the brakes are applied and the time
of the brakes are released by pulse operation.
MODE- If it is selected to INH, the function disables. If it is selected to TH,
the ABS function for THROTTLE brake. When it is selected to AUX, the ABS function for
the AUX channel. If it is selectedto TH&AUX, the ABS function for both THROTTLE and
AUX.
NOTE: the AUX and TH&AUX can select only the Brake MIX set to TH.
14