DragonRC 2.4GHz Transmitter Manual

ManualsBrandsSerpent ManualsCars & TrucksSpyder SRX-2 MM Mid-Motor 2WD RTR 1/10 Electric Buggy

2.15 MIX

MIX 10.2V MIX 10.2V

ST: L50 R50

EN: ON OFF

ST: L50 R50

TH: L50 R50

EN: ON OFF

FUNCTION 10.2V

12: Speed

13. TH HOLD

14. F/S

15. NEUTRAL

This function allows customer to apply mixing between the steering, throttle, and chan-

nel 3 channels.There are main channel and sub-channel in the MIX selection. The servo

travel value of the sub channel is changed along with the change of the main channel

according to the setting rate.

1. Press ‘Roller’ to see FUNCTION MENU.

2. Use the roller to select the BR-MIX function and press the roller.

3. Press the roller to select a item.

4. Firstly main channel setting. Select channel No. (ST, TH, AUX) by rotating the roller.

L and R separately correspond to the rate of Left and Right servos of the main

channel mix

5. Secondly sub channel setting. Select channel No. (ST, TH, AUX) by rotating the roller.

L and R separately correspond to the rate of Left and Right servos selected in

the sub channel.

6. Third Press the roller to select EN item. Use the roller to select ‘ON’ to enable

the function, and ‘OFF’ to disable the function.

7. Press ‘Back’ again to return to save and return to FUNCTION MENU,

press the back again to return to the Main Screen.

For example: current setting: ST: L 50% R 30%. TH: L 20% R 50%. EN: select ‘ON’.

If throttle servo is 60% on the right and rudder servo is 50% on the right, and then

after setting, throttle servo is: 50*30%+60%*50%=45%.

Throttle servo will act along with the action of STEERING servo.

2.16 TH HOLD

FUNCTION 10.2V

TH HOLD 10.2V

12: Speed

13. TH HOLD

14. F/S

15. NEUTRAL

TH HOLD

VALUE: 0%

TH HOLD

- This function allows the Throttle Servo to be

set to a percentage of the total travel range.

This is an alternative to using the motors choke

when starting up the model. Throttle hold can

be performed by pressing the switch to stop

the engine. It can be performed for

accident braking. When pressing the

switch, throttle trigger doesn’t work until

the switch is pressed again.

1. Press ‘Roller’ to see

FUNCTION MENU.

2. Use the roller to select the

TH HOLD function and press the roller.

3. Use the roller to change the value.

4. Press ‘Back’ again to return to save

and return to FUNCTION MENU, press

the back again to return to the Main

Screen.

TERMS:

VALUE - Throttle hold position.

Range: -120% to