DragonRC 2.4GHz Transmitter Manual

2.18 NEUTRAL
NEUTRAL 10.2V
NEUTRAL 10.2V
Set NEUTRAL?
NO YES
READY
Set NEUTRAL?
NO YES
OK
FUNCTION 10.2V
12: MIX
13: TH HOLD
14. F/S
15. NEUTRAL
This function can calibrate the neutral of the STEERING wheel or THROTTLE trigger.
1. Press ‘Roller’ to see FUNCTION MENU.
2. Use the roller to select the NEUTRAL function and press the roller to enter.
3. Use the roller to select YES.
4. Press the roller to calibrate the neutral.
5. Press ’Back’ again to return to save and return to FUNCTION MENU,
press the back again to return to the Main Screen.
Note: Don’t movement the STEERING wheel or THROTTLE trigger in the calibrate
procedure.
2.17 F/S
F/S 10.2V F/S 10.2V
ST: 0% ACT
TH: 0% INH
EN: ON OFF
ST: 0% ACT
TH: 0% INH
EN: ON OFF
FUNCTION 10.2V
12: Speed
13. TH HOLD
14. F/S
15. NEUTRAL
This function does not work in PPM mode. If the RF signal loss, it should occur the
receiver adjust the Steering or Throttle or both to a preset value.
The servo value of Steering channel and Throttle channel in the fail status can
be set through fail safe
Function.
1. Press ‘Roller’ to see FUNCTION MENU.
2. Use the roller to select the F/S function and press ENTER.
3. Press the roller to select a item.
4. Rotate the roller to change the value.
5. Press ’Back’ again to return to save and return to FUNCTION MENU,
press the back again to return to the Main Screen.
TERMS:
ST, to set the servo value of Steering channel. Range -120% to +120%. Default: 0%.
INH, disable this channel Fail Save function. ACT- enable.
20