DragonRC 2.4GHz Transmitter Manual

5
1. The Binding processing
Turn on the transmitter, then turn on the car power switch to
power the receiver, press the receiver ‘BIND’ button untill the
light turns on GREEN which means the binding is successful.
This process only needs to be done once!
Caution: make sure when binding that the RX (receiver) and
TX (transmitter) are within one meter distance maximum, with
no similar operational device within 10 meters. If the light is
ashing, its shows binding failure, please repeat the above
process for binding again.
Connection between receiver and servos (2.4G)
RECEIVER
Spread spectrum mode:FHSS
Channels: 3
Frequency: 2.4G
DC: 4.5~5.5v,%30mA
Net weight: 9.0g
Caution:
Always be sure your reinsert the batteries in the correct polarity order. If the batteries are loaded incorrectly,
the transmitter may be damaged. When the transmitter is not used, always remember to remove the batteries.
If the batteries do happen to leak, clean the batteries case and contacts thoroughly.
Make sure the contacts are free of corrosion.
Battery Disposal. Some countries require special handling of used of batteries, please contact the agencies
responsible for recycling hazardous wastes in your local area. Battery low voltage alarm indicator.
Inserting the Batteries
1. Remove the battery cover from the transmitter
by sliding it in the direction of the arrow .
2. Remove the used batteries.
3. Load the new AA size batteries. Pay very close attention to
the polarity marking and reinsert accordingly.
4. Slide the battery cover back onto the case.
Main specs:
- Dragon-Rc radio DTS-2
Spread spectrum mode:FHSS - Channels: 3
Frequency: 2.4G - DC: 9.6V,%150mA
LCD screen - Net weight: 360g
Battery: 4.8V
Servo 3: Ch 3
Servo 2: TH
Servo 1: ST
ESC
1. This product is equipped for radio controlled models only.
2. We will not be responsible for the (ab)use, damages caused by
unauthorized modication, adjustment or replacement
of parts of this product;
3. The manual may be altered without prior notice. Please contact
us if you have any corrections or clarications that should be
made in the manual.
4. Please pay extra attention to the parts in this manual, which are
marked with ‘Warning’.
5. Before using the transmitter, make sure the transmitter batteries
are well charged. The voltage of transmitter batteries may not
be lower than 8.6V.
6. Check and conrm that the servos are ok and properly connected.
Do not leave this product and its accessories un-attended or
within the reach of children.
Enjoy the use of the Dragon-RC transmitter system!
Warning: