Use and Care Manual

ManualsBrandsSerta ManualsHome DecorErgo-Executive Bonded Leather Office Chair in Black/Silver

Model #: 43676

SUPER TASK

CHAIR

1. To Adjust Tension on The Tilt:

Reach under the front center of the chair, grasp the round

knob and turn counter - clockwise to stiffen the tilt

mechanism. Turn the knob clockwise to loosen the tilt

mechanism. Rotate the knob until the desired resistance is

reached.

2. To Adjust Seat Height:

While seated, reach under the right side of the chair to find

the handle 2. Lift the handle and raise your body up slightly to

allow the chair to rise to the desired height. To lower the

seat, lift the handle while applying more weight downward on

the seat. The chair will descend until the handle is released or

the chair reaches the bottom position.

3. To Operate the Tilt:

While seated, lean backward and reach under the right

side of the chair to find handle 3. When the handle is

placed in the level position, leaning back to allow the

chair to tilt backwards. Push down the handle to lock

the angle while the desired position is reached.

4. To Adjust Back Cushion Angle:

While seated, lean backward and reach under the

right side of the chair to find the handle 4. When the

handle is placed in the level position, tilting your body

backwards to adjust the angle of back cushion, push

down the handle to lock the back angle while the

desired angle is reached.

5. To Adjust Arm Width:

Reach for the knobs underneath the arms located on

bottom of seat cushion. Turn the knobs

counter-clockwise to loosen the width adjustment

feature then turn the knobs clockwise to tighten when

you have reached your desired width.

6. To Adjust Arm Height:

Press the buttons on the chair arms. Press the buttons

to allow the arms to move up or down freely then

release the buttons once the desired height is reached.

7. To Adjust Mechanical Lumbar:

While seated, reach to the right side of the back cushion to

find the adjustment knob for the mechanical lumbar. Turn

the knob clockwise to increase the lumbar support. To

reduce the lumbar support, turn the knob counter –

clockwise. Turn the knob until the desired support is

reached.

OPERATING INSTRUCTIONS

Summary of content (2 pages)

PAGE 1
S U P E R TA S K C H A I R OPERATING INSTRUCTIONS 1. To Adjust Tension on The Tilt: Reach under the front center of the chair, grasp the round knob and turn counter - clockwise to stiffen the tilt mechanism. Turn the knob clockwise to loosen the tilt mechanism. Rotate the knob until the desired resistance is reached. 2. To Adjust Seat Height: While seated, reach under the right side of the chair to find the handle 2.
PAGE 2
S U P E R TA S K C H A I R P A R T S Part # 1. 2. 3. 4. 5. 6A. 6B. 7. 8. 9. 10. 11. 12. 13. 14. 15. L I S T Description Casters 5 Star Base Telescoping Cover Gas Lift Seat Plate Left Arm Right Arm Seat Cushion Back Cushion Back Support Plate (already attached to the back cushion) 1-1/4” Screws 1” Screws Flat Washers (pre-assembled with arms) Lock Washers (pre-assembled with arms) Knobs (pre-assembled with arms) Allen Key Quantity 5 1 1 1 1 1 1 1 1 1 2 2 2 2 2 1 Diagram 1 A S S E M B L Y A. B. C. D. E.