User Manual

Customer Service Support: 1-800-379-9773

Step 2

Align Seat Plate (4) over pre-drilled holes on the

underside of the Seat Cushion (6) with black tension

knob facing the front of the seat. Attach the Seat Plate

(4) to Seat Cushion (6) using 2 Bolts (A1) in the front

holes of Seat Plate (4) and 2 Bolts (A2) in the rear holes

of Seat Plate (4) as shown. Tighten all the screws with

the enclosed Allen Key (B). Be careful not to cross

thread bolts or damage the seat.

TO OPERATE TILT LOCKOUT

Reach underneath the right side of chair and locate the flat-surfaced

handle. Slide the handle all the way out (away from the seat). When

the handle is in this position, leaning back will cause the chair to tilt

backwards. To lock the chair in the upright or vertical position, sit

upright and push the handle in (towards center of seat).

Operating Instruction