PRODUCT GUIDE & ASSEMBLY INSTRUCTIONS Sofa So comfortable, you’ll feel the difference the moment you sit down.
Should you prefer to speak with a customer service representative, you may call toll free: 1-855-372-2315 2
Guidelines FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY • Do not stand on the item or use as a step ladder • Do not use this item unless all bolts and screws are firmly secured and fastened. • Check all bolts and screws every 90 days. As necessary tighten if any are loose. • Lift up then move. Pushing over or dragging this product can result in an injury or cause damage to the floor and piece.
WARNING: DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF INJURY. Pre-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. • Clear out the space for assembly and lay out all parts on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
Parts List 1 Left Roll Arm (1) 2 Front Rail (1) 3 Base Panel (1) 4 Right Roll Arm (1) 5 Back Frame (1) 6 Legs (4) 5
Parts List 6 7 Seat Cushion (2) 8 Seat Cushion Covers (2) 10 Back Cushion Covers (2) A Thumb Bolts (2) 9 Back Cushion (2)
Step 1 1. Ensure all parts have been removed from the carton and place on a protected surface or carpet. 2. Check all parts and hardware are the same as the “Parts List”. 3. Remove the plastic caps on the threaded bolt of each Leg (6) as image. Attach the Legs (6) to the Right Arm (4) & Left Arm (1).
Step 2 1. Attach Front Rail (2) to Left Arm (1) by click the bracket into the mechanism posts located on sides of Arm (1), press down Front Rail (2) then move Front Rail (2) to attach to the Right Arm (4), press down on both sides of the Front Rail (2) to firmly secure.
Step 3 1. Slide the bracket on Back Panel (5) into the mechanism posts located on sides of Left Arm (1) & Right Arm (4) until fully engaged.
Step 4 1. Slide the bracket on the center of Base Panel (3) into the mechanism posts located on the center of Back Panel (5) & slide the bracket on side of base Panel (3) into the mechanism posts located on sides of Left Arm (1) & Right Arm (4) until fully engaged.
Step 5 1. Open back cover and insert Thumb Bolts (A) x 2 into the holes on the Back Frame (5) that connect to the Arms (1) & (4) and the tighten the bolts. 2. Secure the back cover to the hook & loop strip.
Step 6 1. Open the vacuum packed Seat Cushions (7)x2 by carefully cutting the bags with a pair of scissors. Insert the Seat Cushion (7) into the appropriate Seat Covers (8) as image (1). Ensure the cushion cover completely covers the filler as image (2). When closeing the zipper ensure as image (3) the cushion is compressed, this will allow the zipper to close with ease. 2. Insert the Back Cushions (9)x2 into the appropriate Back Covers (10)x2. 3. Fluff all cushion to allow them to expand. 4.
Product Dimension 61"/155 73"/185 m 78"/198c 18.5"/47cm 34.
Limited Warranty The manufacturers products are warrantied against defects in material and workmanship while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as the party or entity which purchases this manufacturer’s furniture from an authorized retailer as shown by the original sales receipt. This warranty does not apply to “as is” or previously owned products.