ASSEMBLY INSTRUCTIONS Bookshelf So Comfortable, the moment you sit down.
Should you prefer to speak with a customer service representative, you may call toll free : 1-855-372-2315 U.S. 6am - 5pm PST 0-800-051-6775 U.K.
Guidelines FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY • Do not stand on the item or use as a step ladder • Do not use this item unless all bolts and screws are firmly secured and fastened. • Check all bolts and screws every 90 days. As necessary tighten if any are loose. • Lift up then move. Pushing over or dragging this product can result in an injury or cause damage to the floor and outdoor piece.
Pre-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. • Clear out the space for assembly and lay out all parts on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. • Keep small parts and pieces away from children and pets until fully assembled.
Parts List (1) Shelf x 5 (2) Leg Panel x 2 5
Parts List 6 (A) Bolts M8x10MM x 20 (B) Dome Nut M8 x14MM x 20 (C) Foot Pad x 4 (D) Wrench 14MM x 1
Step 1-- 1. Ensure all parts have been removed from the carton and place on a protected surface or carpet. 2. Check all parts and hardware are the same as the “Parts List”. 3. Attach Shelf (1) to Legs Panel (2) top position. Secure using Bolt (A) with Dome Nut (B) by using Wrench (D). 4. Repeat to assemble Shelves (1) x4 to Legs panel (2) and secure using Bolt (A) with Dome Nut (B) by using Wrench (D) as below image. Note: Please do not fully tighten all Bolts until the console is fully assembled.
Step 2-- 8 Secure Foot Pad (F) on the bottom of Leg panel as below image.
Step 3-- Place the rack onto a flat level surface and level the frame. Once the table is level, tighten all Nut (B) by Wrench (D) . Periodically (every 90 days) make sure that the screws are still fully tightened. ATTENTION: Be certain that all screws are fully tightened before using table.
Step 4-- WE STRONGLEY RECOMEND THIS UNIT IS ATTACHED TO THE WALL TO PREVENT TOPPLE. KEEP YOUR PRODUCT SAFE FROM INJURY. Wall straps are already pre-assembled on your Furniture. Assembly Steps to attach your furniture to a wall 1. Use a pencil to mark the fixing positions on the wall. 2. Drill holes and insert appropriate wall plugs into wall (not provided). 3. Place the product against the wall, ensure the strap under top panel. 4.
Product Dimension 11
Limited Warranty The product you have purchased is warranted against defects in material and workmanship while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as that party or entity which purchases these products from an authorized dealer or retailer as shown by the original sales receipt. This warranty does not apply too “as is” or previously owned products.
