Specifications

102  Advanced Operations
Installation and Operations Manual
Setting the DNS IP address:
The Set DNS command sets the TCP/IP address of the Domain Name server (DNS).
NOTE: LDAP requires the definition of at least one Domain Name System (DNS) server.
To display the DNS configuration information, use the Show Network command as described on page 69.
To set the DNS IP address:
At the Switched CDU: prompt, type set, followed by dns1 or dns2 and the Domain Name server’s IP
address. Press Enter.
NOTE: Both IPv4 and IPv6 formats are accepted for IP address.
Example
The following command sets the primary Domain Name server IP address to 98.76.54.254:
Switched CDU: set dns1 98.76.54.254<Enter>
Verifying the DNS configuration:
The Ping command can be used to verify the configuration of the DNS IP address.
To verify the DNS configuration:
At the Switched CDU: prompt, type ping, followed by the domain component of the Directory Services
server previously configured and press Enter.
Example
The following command verifies the DNS configuration:
Switched CDU: ping servertech.com
Pinging servertech.com [98.76.54.32] with 64 bytes of data:
Reply from 98.76.54.32: bytes=64 pseq=0 triptime=0
Reply from 98.76.54.32: bytes=64 pseq=1 triptime=0
Reply from 98.76.54.32: bytes=64 pseq=2 triptime=0
Reply from 98.76.54.32: bytes=64 pseq=3 triptime=0
Reply from 98.76.54.32: bytes=64 pseq=4 triptime=0
Configuring LDAP Groups
Creating an LDAP group:
The Create LDAPGroup command creates an LDAP group.
To create an LDAP group:
At the Switched CDU: prompt, type create ldapgroup, optionally followed by a 1-16 character group
name (Spaces are not allowed, and LDAP group names are not case sensitive). Press Enter.
Example
The following command creates the LDAP group PowerUser:
Switched CDU: create ldapgroup PowerUser<Enter>
Removing an LDAP group:
The Remove LDAPGroup command removes an LDAP group.
To remove an LDAP group:
At the Switched CDU: prompt, type remove ldapgroup, optionally followed by a group name. Press
Enter.