Specifications

Advanced Operations  115
Installation and Operations Manual
Setting the number of RADIUS server retries:
The Set RADIUS Retries command specifies the number of times an authentication request is sent to
the RADIUS server. The PT22 will attempt authentication with the primary server until the number of
retries is reached, then will attempt authentication with the secondary server. If the PT22 does not
receive a response from these attempts, the authentication request will be rejected.
Enter the number of retries in the Primary and/or Secondary Retries field and press Apply.
The valid retries range is 0-10; default is 2.
To set the number of retries:
At the Switched CDU: prompt, type set radius, followed by primary or secondary, followed by
retries, and followed by the number of retries (0-10). Press Enter.
Examples
The following command sets the retries for the primary RADIUS server to 5:
Switched CDU: set radius primary retries 5<Enter>
The following command sets the retries for the secondary RADIUS server to 2:
Switched CDU: set radius secondary retries 2<Enter>
Displaying RADIUS configuration information:
The Show RADIUS command displays RADIUS configuration information.
To display the RADIUS configuration information:
At the Switched CDU: prompt, type show radius and press Enter.
Example
The following command displays the RADIUS configuration information:
Switched CDU: show radius<Enter>
RADIUS Configuration
RADIUS: Enabled
Auth Order: Remote->Local
Primary
Server:
Shared Secret: ****
Port: 1812
Timeout: 15 seconds
Retries: 5
Secondary
Server:
Shared Secret:
Port: 1855
Timeout: 5 seconds
Retries: 2