Specifications
42 Operations
Installation and Operations Manual
Command Line Interface
Logging In
IMPORTANT: The Command Line Interface (CLI) was modified to allow both IPv4 and IPv6 settings.
Logging in through Telnet requires directing the Telnet client to the configured IP address of the unit.
Logging in through the Console (RS232) port requires the use of a terminal or terminal emulation
software configured to support ANSI or VT100 and a supported data rate (300, 1200, 2400, 4800, 9600,
19200, 38400, 57600, or 115200 BPS) - 8 data bits-no parity-one stop bit and Device Ready output
signal (DTR or DSR).
To log in by RS-232 or Telnet:
1. Press Enter. The following appears, where x.xx is the firmware version:
Sentry Switched CDU Version x.xx
Switched CDU:
NOTE: Logging in by Telnet will automatically open a session. Pressing Enter is not necessary.
2. At the Username: and Password: prompts, enter a valid username and password. And press Enter.
You are given three attempts to enter a valid username and password combination. If all three fail,
the session ends.
NOTE: The default username/password is admn/admn.
When you enter a valid username and password, the command prompt (Switched CDU:) appears. If a
location identifier was defined, it will be displayed before the Switched CDU: prompt.
You can enter commands in any combination of uppercase and lowercase. All command characters
must be entered correctly; there are no command abbreviations. A user must have administrative
privileges to use the administration commands. The following tables list and briefly describe each
command.
Operations Command Summary
Command Description
Connect Connects to a serial/Pass-Thru port
Envmon Displays the status of the integrated Environmental Monitor
IStat Displays the status of the infeeds
List Ports Lists all accessible serial/Pass-Thru ports for the current user
Login Ends the current session and brings up the Username: prompt
Logout Ends a session
Password Changes the password for the current user
Quit Ends a session
UPSStat Displays the status of the associated UPS devices