Specifications

48  Operations
Installation and Operations Manual
Displaying infeed status:
The Istat command displays the status of one or more infeeds.
This display includes the infeed absolute and descriptive names and the input status and current load
reported to the PT22 by the infeed, branch, or phase.
To display status of one or more infeeds:
Type istat and press Enter.
Examples
The following command displays the infeed status:
Switched CDU: istat
Input Input Input Voltage Load Power
Feed ID Feed Name Status <V> <A> <W>
.AA TowerA_InfeedA On 121.0 0.00 0
Connecting to a serial device:
The Connect command allows Pass-Thru serial connection to devices attached to the standard serial
port (Console).
To connect to a serial device:
At the Switched CDU: prompt, type connect console and press Enter.
To disconnect from a serial device:
Type !*break and press Enter.
Displaying the status of the Environmental Monitor
The Envmon command displays the status of the integrated Environmental Monitor.
By default, only administrative user accounts are allowed access to the Envmon command. An
administrator user can issue the Set User Envmon command to enable and disable access for other user
accounts.
To display the status of the Environmental Monitor:
At the Switched CDU: prompt, type envmon and press Enter.
Example
The following command displays the status of the Environmental Monitor.
Switched CDU: envmon<Enter>
Environmental Monitor .A
Name: Florida_HQ_1 Status: Normal
Temperature/Humidity Sensors
ID Name Temperature Humidity
.A1 Temp_Humid_Sensor_A1 23.0 Deg. C 18 % RH
.A2 Temp_Humid_Sensor_A2 24.5 Deg. C 18 % RH
Changing a password:
The Password command changes the current user’s password. For security, when you type a password,
the characters are not displayed on the screen.
To change a password:
At the Switched CDU: prompt, type password and press Enter.
At the Enter Current Password: prompt, type the current password and press Enter.
At the Enter New Password: prompt, type the new password and press Enter. Passwords can contain 1-
16 characters.
At the Verify Password: prompt, retype the new password and press Enter.