Specifications

Operations  59
Installation and Operations Manual
Environmental Monitor Administration
Creating a descriptive Environmental Monitor name:
The Set Envmon Name command assigns a descriptive name to the integrated Environmental Monitor.
This descriptive name is displayed when the Evnmon command is issued.
To create an Environmental Monitor name:
At the Switched CDU: prompt, type set envmon name followed by the absolute environmental monitor
name, then the descriptive name of up to 24 alphanumeric and other typed characters - (ASCII 33 to
126 decimal) are allowed; spaces are not allowed. Press Enter.
Example
The following command adds the descriptive name Florida_HQ_1to the Environmental Monitor:
Switched CDU: set envmon name .a Florida_HQ_1<Enter>
Creating a descriptive temperature/humidity sensor name:
The Set Envmon THS Name command assigns a descriptive name to a temperature/humidity sensor.
This descriptive name is displayed when the Evnmon command is issued.
To create an temperature/humidity sensor name:
At the Switched CDU: prompt, type set envmon ths name followed by the absolute name of the
temperature/humidity sensor, then the descriptive name of up to 24 alphanumeric and other typed
characters - (ASCII 33 to 126 decimal) are allowed; spaces are not allowed. Press Enter.
Example
The following command adds the descriptive name T/H2_Florida_HQ_1 to the second
temperature/humidity sensor:
Switched CDU: set envmon ths name .a2 T/H2_Florida_HQ_1<Enter>
Serial Port Administration
Creating a descriptive serial port name:
The Set Port Name command assigns a descriptive name to a serial port. You can use this name in
commands that require a port name as an alternative to using the port’s absolute name.
To create an port name:
At the Switched CDU: prompt, type set port name followed by the absolute outlet name, then a
descriptive name of up to 24 alphanumeric and other typed characters - (ASCII 33 to 126 decimal) are
allowed; spaces are not allowed; port names are not case sensitive. Press Enter.
Example
The following command adds the descriptive name Rack1 to Console port:
Switched CDU: set port name console Rack1<Enter>
Setting the serial ports data-rate:
The Set Port Speed command sets the default data-rate for the serial port.
Valid data-rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600 and 115200.
To set the serial port data-rate:
At the Switched CDU: prompt, type set port speed, follow by the data-rate and press Enter.
Example
The following command sets the serial ports data-rate to 38400 BPS:
Switched CDU: set port speed 38400<Enter>