Specifications

Operations  61

Installation and Operations Manual

Creating a location description:

The Set Location command specifies text that appears in the Web control screen’s Location field. The

text is also appended to a Welcome to banner that appears when a user successfully logs in serially or

through a Telnet session.

If you do not issue this command, or if you issue this command without specifying any text, the control

screen’s Location field will be blank and no Welcome to banner will be displayed.

To create a location description:

At the Switched CDU: prompt, type set location followed by a descriptive name of up to 24

alphanumeric and other typed characters - (ASCII 33 to 126 decimal) are allowed; spaces are allowed.

Press Enter.

Omitting any characters after typing the Set Location command deletes any previously specified text.

Examples

The following command specifies Florida HQ as the descriptive location for the control screen and the

Switched CDU: set location Florida HQ<Enter>

The following command deletes any previously specified location description:

Switched CDU: set location<Enter>

In this case, the control screen’s Location field will be blank, and no welcome banner will be displayed

after a successful login.

Setting the system area:

The Set System Area command is used to set the total area for the system. This value is used for total

system power calculations.

To set the system area:

At the Switched CDU: prompt, type set system area, followed by the system area (in square feet) and

press Enter.

Example

The following command sets the total system area to 6.3 square feet:

Switched CDU: set system area 6.3<Enter>

Setting the system area unit of measure:

The Set System Area Unit command sets the value for the system area footprint in either square meters

or square feet.

The default unit of area is a square meter.

To set the system area unit of measure:

At the Switched CDU: prompt, type set system areaunit, followed by squaremeter or squarefoot, and

press Enter.

Setting the system input power factor:

The Set System PF command is used to set the input power factor for the system. This value is used for

system power calculations.

To set the system input power factor:

At the Switched CDU: prompt, type set system pf, followed a value from .50 to 1.00 and press Enter.

Example

The following command sets the system input power factor to 0.8:

Switched CDU: set system pf .8<Enter>