Paper Shredder User Manual

ASSEMBLY

RC12 12-05 Assembly Section 3-4

ASSEMBLY

• Place key (item 1) in end of jackshaft and slide round end of PTO shaft over jackshaft. Attach with two 3/8"

set screws (item 2). Align set screws with dimples in jack shaft. Apply thread locking compound to threads

to prevent loosening. Ensure driveline and jackshaft U-joint are in phase. Asm-FL-0066.

• Place jack shaft shield (item 1) in place over shield mount (item 2) and bearing stand. Fasten in place with

two 3/8" bolts, lockwashers and washers at shield mount and on either side of bearing mount. Asm-FL-

0067.