Assembly Instructions for Actobotics® Linear Actuator Kit 637213 Motor and Motor Mount Not Included.
Kit Contents: Clamping Hub 6mm D-Bore SKU: 545618 QTY: 1 1/8" Thick Hub Spacer SKU: 545372 QTY: 1 8mm Lead Screw Nut SKU: 545315 QTY: 1 8mm Lead Screw Collar SKU: 3504-0804-1808 QTY: 1 8mm ID Thrust Bearing SKU: 1613-0516-0008 QTY: 2 10.50” Channel SKU: 585452 QTY: 1 Clamping Hub 8mm Bore SKU: 545624 QTY: 1 8mm Bore Pillow Block SKU: 535094 QTY: 1 48 Tooth, 32 Pitch Hub Gear SKU: 615190 QTY: 2 8mm Lead Screw 350mm Length SKU: 3501-0804-0350 QTY: 1 10.
STEP 1 Use eight 1/4" screws to attach the Dual Side Mounts to the X-Rail Slide Plates. 632106 STEP 2 Mount the two slide plate assemblies into the channel as shown using eight 5/16" screws.
STEP 3 Attach a clamping motor mount as shown. This kit does not include the motor or motor mount but as an example we are showing 555176 (32mm bore). We've included a plastic motor mount spacer. This can be helpful to adjust gear mesh spacing depending what what motor/motor mount you are using. 632108 STEP 4 Bolt the Lead Screw Nut and Pattern Spacer to the end of the X-Rail as shown using four 7/16" screws.
STEP 5 Slide the X-Rail into the X-Rail Slide Plates. Start to feed the Lead Screw into the Lead Screw Nut. STEP 6 Put the collar and one thrust bearing onto the lead screw. Next, fasten the pillow block with 4 screws as shown. Slide the second thrust bearing onto the lead screw. Leave the collar and thrust bearings loose at this point.
32108 STEP 7 Fasten the gears to the hubs using eight 5/16" screws. STEP 8 Put the gear assembly which has the 8mm bore hub onto the lead screw. Slide the collar and hub towards each other until the thrust bearings contact the pillow block. Tighten the pinch bolts on the collar and hub.
STEP 9 Slide the motor into the clamping mount. Slide the gear assembly with the 6mm D-Bore hub on the motor shaft until the hub bottoms out against where the flat of the motor's d-shaft stops. Tighten the pinch bolt on the hub. Slide the motor until both gear faces line up with each other. Note that this kit does not included a motor or motor mount but as an example we are showing a 555176 clamping mount and a 5202-0002-0005 Yellow Jacket Planetary Gear Motor from goBILDA.
