Manualshelf

Data Sheet

ManualsBrandsServoCity ManualsLinear ActuatorsServoCity 7.4-Inch Linear Actuator Kit
1234567
STEP 9
Slide the motor into the clamping mount. Slide the gear assembly with the 6mm
D-Bore hub on the motor shaft until the hub bottoms out against where the flat
of the motor's d-shaft stops. Tighten the pinch bolt on the hub. Slide the motor
until both gear faces line up with each other. Note that this kit does not included
a motor or motor mount but as an example we are showing a 555176 clamping
mount and a 5202-0002-0005 Yellow Jacket Planetary Gear Motor from goBILDA.