Quick Start Guide

Connect your machine to the same network as the AP
Plug in the power supply of the access point
During the boot process of the access point, start the ESL server software on the computer
(see point 2.1)
When the access point is booted up, the server will discovery it with an IP address ( :
The discovering process may take up to 2 minutes)
Use the ESL client to connect to your ESL server
Under System – Access Point Status – the AP should be listed as discovered (after successful
boot sequence)
One Column of the AP should show now the IP address
Now you’re able to configure the access point via web-GUI under http://<DHCP-IP-address>
or a right click on the discovered AP –> Open in browser…
In the status overview you get some details about the AP-2010:
Figure 13 - AP-2010 Status overview
It’s recommended for the demo installation not to use the “Auto-Config” feature and configure the
AP manually.
The following actions need to be performed over the web-GUI
(1) Deactivate Auto-Config: Administration -> Auto-Config
(2) Set up network details (or leave DHCP): Administration -> Network
(3) Set up a wireless channel: Administration -> Wireless
The AP-2010 supports 11 wireless channels. It’s recommended to choose one of
the recommended channels: 3, 5, 8, 9 or 10. These channels do not interfere