Quick Start Guide

with standard Wi-Fi channels 1, 6, 11 and are scanned by the labels more often
For further information about selecting channels see point 3.4.
After the configuration in the web-GUI it’s necessary to add this AP via the ESL Client: System ->
Access Point Configuration -> New …
Figure 14 - ESL Client AP configuration - System -> Access Pont Configuration -> New
Choose “Manual Configuration” if you don’t use Auto-Config and enter Access Point ID (AP ID) and IP
address (Host).
: After the basic configuration in the web-GUI, it is also possible to fill in AP-ID and AP-IP-
Address automatically. For this choose "Create Configuration..." under System - Access Point Status -
Right click on the discovered and configured Access Point.
After saving the AP configuration you should see the AP under System -> Access Point Status as
ONLINE. In addition the AP status LED should turn .
For a working installation a channel must be selected on each access point in the network. There are
11 non overlapping ESL channels reserved for the communication with the labels. Five of these
channels do not interfere with typical Wi-Fi installations and should therefore be favored. These are