Quick Start Guide
Table Of Contents
- [Introduction]
- 1 Electronic Shelf Labeling – A brief introduction
- 2 The G1 label family
- 3 What’s in your Smart Box?
- [Getting Started]
- 1 Latest Software and Documentation
- 2 Install software
- 3 Start Server and Client
- 4 Connect and configure Access Point AP-2010
- 5 Setup Security
- 6 Register labels
- 7 Start tagging
- 8 Integration
- [Troubleshooting]
- 1 FAQ
- 1.1 Running the ESL Server as a background service
- 1.2 Where can I find the license file for my SmartBox?
- 1.3 Deleting the demo articles
- 1.4 Establish a network configuration when no DHCP is available – Step by step
- 1.5 AP discovering with Bonjour Services
- 1.6 What can I do if the Status LED of the AP-2010 access point doesn’t turn blue?
- 1.7 Labels don’t come online
- 1.8 The encryption does not work
- 1.9 Unlocking labels
- 1.10 Starting Java applications
- 1.11 Encoding problems
- 1.12 Further documentation
- _Ref387048594
- _Ref386612307
- _Ref386612318
- Activati
- _Ref384813549
- _Ref388607844
- _Ref388607849
Quick Start Guide imagotag GmbH
Page 20 of 36
6.2.1 Labels before and after registration
Page Layouts G1 4.4
Layout when shipped
Registration Page Layout
Note:The label ID can only be read and will not be
displayed as barcode in this layout.
Layout after successful registration
Reset Page Layout
Note: After successful registration, the AES key is
exchanged for encryption and the label switch to a page
where only the label ID is displayed as 1D Code128
barcode.
The sticker (on the bottom and on the back) always contain only the label ID and therefore should
not be used for registration. They are only intended for the later article assignment (matching
process).
Here you can see the registration dialog in the ESLClient where one single label has been entered
with the registration code and the other one with the label ID (for old label versions < 3.0.0).
FIGURE 1-18: Register labels dialog (registered with registration code and label ID)