Product Specs

Page 21 of 29
9 Battery Replacement
9.1 Audience
Only persons with the following knowledge are allowed to replace the battery:
l Battery
l Electronic assemblies like circuit board
l Compliance of the instructions
9.2 Instructions
l Risk of explosion through incorrect battery replacement.
l Use battery pack exclusive provided from the company imagotag GmbH.
l Keep attention that your hands are dry before you start with the replacement.
l Don’t use sharps to open the label.
l Don’t use your fingernails to open the label.
l Don’t touch the circuit board of the open label.
9.3 Steps
9.3.1 G1 retail 1.6 red
1. Press a coin in the coin slot on the back side of the label (hidden behind the nameplate).
2. Turn the coin with pressure contraclockwise.
3. Take away the battery cover.
4. Take out the coin cell.
5. Put in the new coin cell.
6. Put the battery cover back on the label.
7. Press a coin in the coin slot on the battery cover and turn it clockwise.
9.3.2 All labels except G1 retail 1.6 red
1. G1 retail 2.2 red, G1 retail 2.6 red and G1 retail 2.7 (red): Press both snap-in-mounts of
the battery cover (backside of the label) until the battery cover detaches. Afterwards
take the battery cover from the label. G1 retail 4.2, G1 retail 4.4 (red) and G1 retail 7.4
(red): Use the imagotag battery cover tool to open the battery cover. Afterwards take
the battery cover from the label.
2. Pull the white plug out of the socket, don’t pull on the cable.
3. Take out the battery pack.
4. Put in the new battery pack.
5. Push the white plug in the socket.
6. Put the battery cover on the label casing (the arrows have to show to each other)
7. Check if the power status of the label switch to "GOOD" otherwise contact the imag-
otag support (
[e-mail]).
We can also provide some battery replacement videos, for more information about that please
contact the imagotag support (
[e-mail]).