Quick Start Guide

Quick Start Guide
Page 23 of 50
l Knowing the IP address of the AP-2010
l WLAN activated
Important Note: AP-2010 and the computer on which the imagotag Core Service runs should be
connected via Ethernet and not via WiFi, as this will result to regular failures.
5.2.2 Access Point IP
Before labels are able to communication with the server at least one access point needs to be
configured. After setting up the basics you should know the IP address of your AP-2010:
URL: http://<LANCOM/MAP-IP-address>
Login with the password set before.
FIGURE 1-18: Figure - LANCOM Web GUI Login
5.2.3 Configuration: Wireless ePaper
Under “Configuration – Wireless ePaper” you can check whether the module is activated or not.
You can also select a channel or leave the “Automatic selection” (recommended).
FIGURE 1-19: Figure - Configuration - Wireless ePaper
The AP-2010 supports 11 wireless channels. It’s recommended choose one of
the recommended channels: 3, 5, 8, 9 or 10. These channels are scanned by
the labels more often.
5.2.4 LCOS Menu Tree
Here you’ll find the necessary information for the imagotag Core Service Access Point
Configuration settings.
5.2.5 Setup – Wireless ePaper
Navigation: “LCOS Menu Tree – Setup – Wireless ePaper”