Quick Start Guide
Table Of Contents
- [Introduction]
- 1 Electronic Shelf Labeling – A brief introduction
- 2 What’s in your Smart Box?
- 3 The G1 label family
- 4 Core appliance
- [Getting Started]
- 1 Get the latest software and documentation
- 2 Install software
- 3 Core appliance initial setup
- 4 Start Core Service and Control Center
- 5 Access Point Configuration
- 6 Setup Security
- 7 Register labels
- 8 Start tagging
- 9 Integration
- [Troubleshooting]
- 1 FAQ
- 1.1 imagotag Core Service Dashboard
- 1.2 Running the imagotag Core Service as a background service
- 1.3 Where can I find the license file for my SmartBox?
- 1.4 Deleting the demo articles
- 1.5 Labels don’t come online
- 1.6 The encryption does not work
- 1.7 Unlocking labels
- 1.8 Starting Java applications
- 1.9 Encoding problems
- 1.10 Further documentation
- _Ref387048594
- _Ref386612307
- _Ref386612318
- _Toc409448034
- Activati
Quick Start Guide
Page 30 of 50
7.2.1 Labels before and after registration
Page Layouts G1 4.4
Layout when shipped
Registration Page Layout
Note:The label ID can only be read and will not be
displayed as barcode in this layout.
Layout after successful registration
Reset Page Layout
Note: After successful registration, the AES key is
exchanged for encryption and the label switch to a page
where only the label ID is displayed as 1D Code128
barcode.
The sticker (on the bottom and on the back) always contain only the label ID and therefore
should not be used for registration. They are only intended for the later article assignment
(matching process).
Here you can see the registration dialog in the imagotag Control Center where one single label
has been entered with the registration code (Pin =yes - security enabled)and the other one
with the label ID (for old label versions < 3.0.0, Pin =no, no secured communication).