Tus neeg siv phau ntawv

COMMON 12V POWER SUPPLY ISSUES
Wiring
Often the standard wiring from the car battery to the 12V outlet is too small.
A minimum 6mm automotive wiring should be used and the earth should be
wired directly back to the battery.
Battery
The car battery could be old, undersized or have a dead cell causing too
much voltage drop.
Connections
The 12 V plug, car 12 V socket or any of the connections between the
fridge and the battery could be faulty or have come loose since installation.
TIPS
1) Use the product in MAX mode in these cases:
- use of the product as refrigerator with high ambient temperature;
- when the suitable temperature need to be achieved in few time.
2) Use the product in ECO mode in these cases:
- use of the product as refrigerator and, in particular, with low ambient temperature;
- when the vehicle is parked for long time (with engine switched off)
USING THE REFRIGERATOR IN A VEHICLE
- Make sure the polarity is right.
- The supply line is protected by a 15 A fuse located on the box.
- If connected to an existing cigarette plug, carefully check up that power supply is sufficient.
- If the supplied power cable is not used, see the table containing the information related to
the cable section:
CABLE AREA
2
mm
MAX CABLE LENGHT METRES (ft)
12V 24V
2,5 (AWG 13) 2,5 (8 FT) 5 (16FT)
4 (AWG 11) 4 (13 FT) 8 (26 FT)
6 (AWG 9) 6 (20 FT) 12 (40 FT)
- Connect the feeding cable to a direct current 12 or 24 V DC power source.
(AWG)
CUT IN / CUT OUT
Your fridge has built in battery protection and needs a minimum 10.9 V to start and 9.6 V to continue operating.
During operation a load is placed on the power supply and voltage can drop by as much as 2 V, especially if the
wiring in insufficient (less than 6mm direct to battery) or if there is a loose connection somewhere.
If this occurs when you try and start your SetPower and the power supply drops under 10.9 V it will not start.
If this occurs when your SetPower is running and the power supply drops below 9.6 V it will stop.
06