Model 3100/3200 High-Pressure Pressure Transducer Installation Guide 800-257-3872 ° Fax: 978-264-0292 Web Address: www.setra.com Email: sales@setra.
Installation Guide 1.0 Setra Systems Model 3100/3200 Pressure Transducer GENERAL INFORMATION Every Model 3100/3200 has been tested and calibrated before shipment. Setra Systems 3100/3200 pressure transducers sense gauge pressure and convert this pressure difference to a proportional high level analog output. The following standard output and excitation versions are offered: Excitation 10 to 30 VDC 5 VDC ±10% 2V above Full Scale to 30 VDC max @ 4.5mA 2.
the installation: The product is installed outside; all or any part of the cable is exposed to the outside; the cable is greater than 30 meters in length. In order to meet the Surge Immunity requirements, the following conditions must be followed during installation: 1. Shielded cable must be used, and the shield must be tied to earth ground (not power supply ground) on at least one end of the cable shield/drain wire. The shield must be maintained all the way from sensor to the power supply. 2.
Electrical Connections, Diagram A (see page 7 for mating connectors) Deutsch DT04-4P (Code 8) 4 3 1 2 Pin # 1 2 3 1.50 (38) 4 0.75 (19) A 1.53 (39) C 1 4 0.28 (7) 0.76 (19) V out2 (temp) V Supply No Connect V out1 No (pressure) Connect 1 v Supply out1 (pressure) v v 2 3 Amp Superseal 1.5 (Code 6) Pin Voltage Current # Mode Mode V 1 out1 No (pressure) Connect 2 Ground Return 1.02 (26) Supply 1.
2.4 Pressure Fittings (See Diagram B below) NPTF (Dryseal & Standard Tapered Threads): “Dryseal” Pipe threads are designed to seal pressure tight joints without the need of compounds. To accomplish the seal, the root of both internal and external threads are truncated slightly more than the crests, i.e. roots have wider flats than crests.
3.0 Mating Connectors (optional) For use on Part NO.
4.0 RETURNING PRODUCTS FOR REPAIR Please contact a Setra application engineer (800-257-3872) before returning unit for repair to review information relative to your application. Many times only minor field adjustments may be necessary. When returning a product to Setra, the material should be carefully packaged and shipped prepaid to: Setra Systems, Inc.
