USER MANUAL Outdoor Soundbar FOR OUTDOOR DISPL AY SIZES 49-INCH, 55 -INCH, 65 -INCH, 86 -INCH MODEL NUMBERS SPK-49 SPK-55 SPK-65 SPK-86 W W W. SEUR A .
Important Safety Instructions IMPORTANT SAFETY INSTRUCTIONS Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. WARNING – TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THE SET TO RAIN OR MOISTURE. 1) Read these instructions. 2) Keep these instructions. 14) R efer all servicing to qualified service personnel.
Before Installation CAUTION IMPORTANT The display should not be installed directly over a flat surface if heavy or driving rain may puddle and splash up onto the lower portion of the display. Direct sunlight on the display screen will heat internal components and should be avoided. IMPORTANT Le téléviseur ne doit pas être installé directement sur une surface plane, si de fortes pluies ou de conduite peut flaque d’eau et éclabousser sur la partie inférieure du téléviseur.
Beveled Edge Setup Before using the device, please check the following contents of the box for completeness: Beveled Edge Storm Dome Rubber Bumpers Input Caps USER MANUAL Outdoor Soundbar FOR OUTDOOR DISPL AY SIZES 49-INCH, 55 -INCH, 65 -INCH, 86 -INCH MODEL NUMBERS Storm Ultra Bright SPK-49 SPK-55 SPK-65 SPK-86 Storm W W W. SEUR A .
Setup Front View Back View Connections RCA 1 RCA 2 Input Input Service Only Power Input Storm Ultra Bright 5
Installation Vesa/Display Mount Instructions 1. C arefully lay the display face down on a non-marring surface. Position the soundbar face down, with the grill attached, along the desired edge of the display. This will help ensure that the final mounted position of the soundbar is flush/even with the display. WARNING: Ensure the Séura Display is properly supported on a flat surface at least as large as the Display. Pressure on the front of Beveled the LCD panel will damage the unit.
Below illustrations not applicable. Mounting Screw Installation Mounting Screw Mounting Screw (not included) Wall Mount Instructions Wall Mount Bar Mounting Screw (not included) Wall Mount Block 1. Mount the wall mount bar to the wall using appropriate screws. Make sure the bar is installed level with the display. When installed, the top of the soundbar will sit approximately 3/8” higher than the top edge of the wall mount bar. The “A” bottom of the soundbar will be approximately 5.
Operating Instructions Powering On Your Soundbar To power on your Séura soundbar, remove the magnetic grill from the front of the soundbar. Press the power switch in the center of the soundbar. The side with the line should be depressed to power on. Power Switch When powered on, the indicator light will turn on but will turn off 5 minutes later. To power off your Séura Soundbar, press the rocker switch so that the side with the circle is depressed.
Troubleshooting If the product is not working properly, please check the following troubleshooting hints before you contact customer service: Symptoms Possible Solution No audio from RCA input Verify both the audio source device and Soundbar are powered on. Verify signal cables are connected properly and the volume setting on the audio source device is set to an audible level. Verify that Bluetooth is disabled on the Soundbar.
Technical Specifications FRONT VIE W FRONT VIE W FRONT VIE W BACK VIE W BACK VIE W BACK VIE W CONNECTIONS CONNECTIONS CONNECTIONS RCA 1 Input 1 RCA OTHER OTHER OTHER INSTALLATION INSTALLATION INSTALLATION AUDIO AUDIO AUDIO INTEGRATION INTEGRATION INTEGRATION GENERAL GENERAL GENERAL Input OPERATING TEMPERATURE RANGE OPERATING TEMPERATURE RANGE OPERATING HUMIDITY RANGE RCA 2 Input2 RCA Service Only Service Power Input Power Input Only Service Only Power RCA 1 RCA 2 Input Input Input Input
PRODUCT LIMITED WARR ANT Y (“Séura”) Product (the (the “Product” or “Products”) fails to work properly because of abecause defect in of materials or workmanship, will, for the length the for period below, If aa Séura, Séura,Inc. Inc.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.