User Manual

Instruction:
1. Insert the camera mounting platform onto the carbon
fiber tubes as shown in figure 2. If the camera mounting
platform is not able to be inserted onto the tubes, unscrew
the two screws on the rotating plate as shown in figure 1.
Rotate the plate clockwise to ensure the tubes can go
through, then rotate the plate counter-clockwise till the
wheels and the tubes are in proper position, tighten the
screws.
Rotating plate on camera
mounting platform
Rotating plate on camera
mounting platform
Note: The rotating plate on camera mounting platform is
adjustable, and it is designed to adjust the position of
the bearings on the rotating plate.
Loosen the locking screws
Unfold the legs
2. Loosen the locking screws on the support feet, unfold the
legs, then tighten the lockings on the support feet again.
3. Loosen the tube fixer locking screw as shown below , insert
one of the tube fixer to one side of the tubes as shown
below, then tighten the tube fixer locking screw.
Tube fixer locking screw
4. Loosen the tube fixer screw as shown below, insert the other
tube fixer to the other side of the tubes as shown below, then
tighten the tube fixer locking screw.
Tube fixer locking screw
5. Adjust the height/angle of the feet according to your desire,
then fix the screws.You can add a tripod ball head (purchased
separately) on to the camera mounting platform which will
allow you to adjust the angle/position of the camera conv-
eniently, then mount the camera onto the tripod ball head, it
is ready to start shooting now.
Mount on a tripod
6. You can use SK-CFS80 standalone, or you can mount it
on tripod or two tripods as shown below, you can even
use it vertically as shown below.
Mount on two tripods
Use it vertically