Datasheet

ST-352UAG-05E
 INPUT CHARACTERISTICS:
 VOLTAGE: 90VAC ~ 264 VAC
 FREQUENCY: 50 ~60
HZ
 INPUT CURRENT: 10.0A (RMS) FOR 115VAC
6.0A (RMS) FOR 230VAC
 INRUSH CURRENT: 50 A MAX
 SPECIFICATION:
 EFFICIENCY: 68% TYPICAL, FULL LOAD CONDITION AT 115/230 VAC
 POWER GOOD SIGNAL: ON DELAY TIME 100 ~ 500 ms, OFF DELAY TIME 1ms.
 HOLD UP TIME: 17ms AT 25℃ FULL LOAD CONDITION AT 115/230 VAC INPUT.
 OPERATING TEMPERATURE RANGE: 0℃ ~ 50℃.
 REMOTE ON/OFF CONTROL: THE POWER SUPPLY OUTPUT SHALL BE ENABLED WITH AN
ACTIVE-LOW TTL SIGNAL. WHEN TTL SIGNAL IS LOW, THE DC OUTPUTS ARE TO BE ENABLED.
WHEN TTL SIGNAL IS HIGH OR OPEN CIRCUITED, THE DC OUTPUTS ARE TO BE DISABLED.
 OVER POWER PROTECTION: AT 115/230 VAC INPUT THE POWER SUPPLY WILL SHUT DOWN
ALL DC OUTPUT WITH IN 105% TO 140% OF FULL LOAD.
 OVER VOLTAGE PROTECTION: +5V → 6.5V, +12V → 14.5V, +3.3V → 4.5V.
 EMI REQUIREMENT: FCC PART 15 SUB PART J CLASS B AT SYSTEM LOAD, CISPR 22 CLASS B.
 SAFETY: c UL, TUV, CB, CCC, FCC, BSMI, CE
 DIMENSION: 200 (D) x 100 (W) x 70 (H) mm.
 COOLING: ONE 60mm DC FAN.
 ACTIVE POWER FACTOR CORRECTION: EN 61000-3-2: 1995+A1+A2: 1998, CLASS D.
 OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
OUTPUT
VOLTAGE
MIN [A] MAX [A] LOAD LINE
RIPPLE
MAX [P-P]
NOISE
MAX [P-P]
+5V 1.0 25 ±5% ±1% 50mV 50mV
+12V1 1.0 25 ±5% ±1% 120mV 120mV
+3.3V 1.0 17 ±5% ±1% 50mV 50mV
-12V 0 0.8 ±10% ±1% 120mV 120mV
+5VSB 0 2.0 ±5% ±1% 50mV 50mV
1. MAXIMUM CONTINUOUS COMBINED LOAD ON +5V AND +3.3V OUTPUTS SHALL NOT EXCEED 125W.
2. MAXIMUM CONTINUOUS COMBINED LOAD ON +5V, +3.3V, +12V OUTPUTS SHALL NOT EXCEED 334W.
3. MAXIMUM CONTINUOUS TOTAL DC OUTPUT POWER SHALL NOT EXCEED 350W.
Ver. 1.0