Operation Manual
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service departments. e
address can be found in the appendix to
this manual.
Before using for the rst time
Clean the water bowl, the egg holder and lid
with a damp cloth.
How to use your egg boiler
Fill the measuring cup completely with –
cold water and pour the measured
quantity into the water bowl.
Pierce the blunt end of each egg with the –
piercer; this will reduce the risk of the eggs
cracking during boiling.
Place the eggs into the holder, t the –
holder onto the water bowl and put the
lid on.
Use the boiling-time control to select the –
desired degree of hardness:
-
so
-
medium
-
hard
e markings refer to medium-size eggs. –
However, it is possible to adjust the degree
of hardness in nitely, depending on the
number and size of eggs to be boiled.
e size of the eggs to be used can be –
selected underneath the symbols for the
boiling-time control:
For smaller-
sized eggs, use a setting to the le of the
boiling-time control, and a setting to the
right for larger eggs.
If the egg holder is completely full, the –
adjustment wheel should be turned a little
further to the right of the desired level of
hardness.
e perfect degree of hardness very much –
depends on individual taste; should the
eggs turn out too so or too hard, try a
slightly di erent setting next time.
Insert the plug into a suitable wall socket –
and use the On/O switch to turn the egg
boiler on. e indicator light comes on.
A beep is heard once the pre-set cooking –
time for the desired hardness of the eggs
has elapsed.
Switch o the appliance. e indicator –
light goes out. Remove the plug from the
wall socket.
Open the lid. – Caution: when the lid is
opened, hot steam will escape.
Remove the egg holder with the eggs –
from the bowl and place it immediately
under cold running water. Note: if the
eggs are not removed from the boiler and
quenched under cold water immediately,
they will continue to harden.
Let the appliance cool down and pour out –
any remaining water.
Cleaning and care
Always remove the plug from the wall z
socket, allow the appliance to cool down
and pour out any remaining water before
cleaning.
To avoid the risk of electric shock, do not z
clean the appliance with water and do not
immerse it in water.
In order to prevent the polished surfaces z
from being damaged or scratched, do not
use abrasives or harsh cleaning solutions.
Wipe the water bowl with a damp cloth –
only.
Any build-up of deposits on the water –
bowl can be removed using a solution of
water and vinegar. en let the appliance
run through one boiling cycle using
fresh cold water to clean it of any vinegar
residue.
oroughly rinse the egg holder and wipe –
dry a erwards.
e lid may be wiped clean with a damp –
cloth.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
is product is guaranteed against defects
8