manual

Control switch settings
The control switch settings are as follows:
P The appliance remains switched on as
long as the switch is held in this
position.
0 The appliance is switched off.
1 The appliance operates at low power.
2 The appliance operates at maximum
power.
Short-term operation
The appliance is designed to process average
domestic quantities of food; it can be
operated without interruption for a
maximum of 1 minute, when it should be
allowed to cool down for approximately 5
minutes.
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
switched on once the blender jug is properly
locked.
Before removing the blender jug, make sure
that the control switch is in position 0. This
also applies when fitting the blender jug to
the motor housing. If the switch is not in its
off-position (0), the motor will start
immediately.
Operation
- Fit the blender jug to the motor housing.
It can be fitted in any position.
- Turn the safety contact ring so that the
pin activates the safety switch (see
diagrams I and II).
- Put the liquid ingredients into the
blender jug. The jug has a maximum
capacity of 1250 ml. To avoid possible
foaming or spilling when processing
foamable or thin liquids such as milk, do
not fill the jug over the 1000 ml mark.
- Attach the lid. To add ingredients during
operation, the stopper in the centre of the
lid can be removed by turning the
stopper in an anti-clockwise direction
and then lifting it. Do not insert any
objects into the blender jug while the
appliance is operating.
-
Insert the plug into the wall outlet and
use the control switch to select the
required power setting. Depending on
the food to be processed, the appliance
may also be operated for short periods of
time in the pulse setting “P”. Do not
operate the appliance when the blender
jug is empty.
- After using the blender, switch the
appliance off and remove the plug from
the wall socket. Wait until the motor has
come to a complete standstill before
removing the blender jug.
Ice crusher
This blender may also be used to crush ice.
Put the ice cubes into the jug, but do not fill
over the 750 ml mark, and switch the
appliance on. Once the ice cubes are crushed
to the desired size, switch the appliance off
and take out the ice.
General Care and Cleaning
● Always remove the plug from the wall
socket before cleaning the appliance.
● To avoid the risk of electric shock, do not
clean the motor housing or the power
cord with water and do not immerse
them in water. The motor housing may
be wiped with a slightly damp, lint-free
cloth.
● Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning,
and do not clean in a dish-washer.
- For cleaning after use, fill the blender jug
with approximately 1000 ml warm water
with a mild cleaning detergent. Let the
appliance run for a short period as
described in the section Operation. Then
rinse the blender jug, lid and stopper with
fresh water. All parts must me
thoroughly dried afterwards.
8