Installation Guide

J. Press any mortar that has been forced out back

into the joints using a polyfoam brush.

K. Remove all mortar from the glass block faces.

7. Finishing

Note: Allow the mortar to set up for about one hour

before proceeding.

Note: To prevent scratching of the glass DO NOT use

abrasive materials for this cleanup.

A. Twist o the spacer tabs on both sides of the panel.

B. With moderate pressure, run the striking tool over

all the joints. It is best to strike all the horizontal

joints rst, then the vertical joints so the pattern is

uniform. Fill any voids with mortar.

Note: Striking removes excess mortar and compacts

the joint to create a smooth, concave, moisture-proof seal.

C. Use a damp sponge to remove the excess mortar

from the block face, rinsing the sponge frequently.

Do not be concerned about the dry lm that

remains on the blocks, it will be cleaned o later.

Note: Allow the mortar to dry for about two to three hours

before proceeding.