Installation Guide

4. Install The First Row

Note: If your project is framed on 3 or 4 sides, complete

Steps A thru K. If your project is framed on 2 sides, skip

to Step L.

A. Using a trowel apply

approximately a 1/2"

mortar bed to

the treated

curb or

oor.

B. Without applying any mortar to the rst block, place

an “L” spacer at the lower outside corner of the

block so that the spacer cross arm will be at the

bottom, between the glass block and the curb.

C. Place a “T” spacer at the other lower corner of the

block with the spacer cross arm up.

D. Slip a 16" long piece of trimmed expansion

strip between the block and jamb, and push

 theblockrmlyintoplace.

E. Slip a “T” spacer between

the block and jamb so that

the cross arm is on top of

the block.