Installation Guide

5. Installing The Remaining Rows
A. Apply a 3/8" to 1/2" mortar bed on
top of the rst row.
Note: Be careful to keep the smooth legs of the
spacers free of mortar to ensure that the next row of
block will sit at on the spacers.
B. Install panel anchors at both jambs by
completelyembedding them in the
mortar and fastening them
to the jamb.
C. Install Seves
Stainless
Steel Wire
Reinforcing
taking care
Not to overlap
any previously
installed components.
23
E. Place a “T”
spacer at the
upper corner
of this block
against the
jamb.
D. Place a block (without mortar) against
the jamb using spacers that are already
in place from the previous row, for
alignment.
5D
5E
F. Continue with
each block as
you did with
the rst row.
5F
5A
5B
5C