Installation Guide

6. Finishing

Note: Allow the mortar to set up for about one hour

before proceeding.

Note: To prevent scratching of the glass DO NOT use

abrasive materials for this cleanup.

A. Twist o the spacer tabs on both sides of the panel.

B. With moderate pressure, run the striking tool over

all the joints. It is best to strike

all the horizontal

joints rst, then the vertical

joints so that the

pattern is uniform. Fill any voids

with mortar.

O. Screw the short leg of the anchor to the top of the

opening.

P. Continue this two block procedure across the nal row.

After installing the nal block, be sure to press back

into the joints any mortar that has been forced out.

Q. Install the expansion strip across the head.

Note: Because the top course meets the expansion strip

at the head, no mortar is placed at the top edge of these

blocks.

EXPAN

TRIP