Installation Guide

T. Apply mortar so that the long

leg of the anchor is embedded

in the vertical joint.

U. Follow this procedure for the rest of the blocks in the

ÀUVWURZLQVWDOOLQJDSDQHODQFKRUDIWHUHYHU\

2 blocks.

V. Check periodically to ensure that the glass blocks

are straight, level and plumb.

Note:,I\RXÀQGDSUREOHPDGMXVWWKHEORFNLQWR

place with a rubber mallet before proceeding.

W.Using a polyfoam brush, remove

 H[FHVVPRUWDUDQGÀOODQ\YRLGVRQ

both sides of your panel.

S. Install a vertical panel anchor after

the second block and screw the

short leg of the anchor

to the curb. All panel

anchors should be

attached using #12 x 1"

zinc-plated head screws

or equivalent. Use two

screws per anchor.

Note: If attaching

the panel anchors to

tile or masonry, plastic

screw anchors should

be used.