Installation Guide

NOTES:

For Straight Blocks and Finishing Units

a. For walls with angles it is recommended that

you layout your wall before constructing a curb.

Note: If it is necessary to have a joint in the horizontal

spacer, to extend it to t the width of the section, make

sure the joint will align with a vertical spacer. Stagger these

joints on each following row.

b. For straight sections between one jamb and an

End Block, cut the horizontal spacer 1" shorter

than the nominal dimension.

c. For straight sections between a shaped block

and an End Block, cut the horizontal spacer

3/4" shorter than the nominal dimension.

d.ForEndBlock,trimtheendofthespacertot

the shape by cutting the two corners at a 45°

angle 3/4" from each corner.