Instructions / Assembly

I. Check the first row for level lengthwise and crosswise. Make sure
the blocks are straight and plumb.
J. If necessary, insert plastic shims under the channel to level the
row. Use a flat blade screwdriver to lift the channel as you insert
shims.
20
K. Place a horizontal spacer with anchor inserted into the ends, on
top of the first row.
L. Mark the location of the center of the anchor on the jamb. If your
wall has two jambs, mark the centers of the anchors on both
jambs. These marks will be used to draw a plumb line on the
jambs.
M. Removed the top horizontal spacer, block and vertical spacers,
being careful not to disturb the bottom horizontal spacer or shims.
N. Trace the outline of the horizontal spacers and mark the shim
locations.
O. Starting with the center mark of the first anchor, Use a level to
draw a plumb line on the jambs the height of the panel. This will
be the center line for all of the anchors.
2K
2L
2O
2M
(test Fit the First rOw COntinued)