Full Product Manual

Step 2: Refer to the picture below. First, tighten the 6 pre-inserted Long Screws

(marked “A” in the picture). Next, screw in and tighten the 6 Short Screws (B) into the

6 screw holes on the unit (these screw holes are marked “B” in the picture). Do NOT

over tighten the screws.

How to Fold the Tower (If Needed): First, fully loosen and remove all 6 Short Screws

(marked “B” in the picture above) from the unit. Next, fully loosen (about 5 turns), but

do NOT remove, the 6 remaining pre-inserted Long Screws (marked “A” in the picture

above). Finally, carefully fold down the unit. Please note that the unit CANNOT be

folded completely flat. Forcing the unit into a folded position without first removing the

6 Short Screws (B) and fully loosening the 6 pre-inserted Long Screws (A) may result

in irreparable damage to the unit.

Resin 3-Tier Tower

Model No. FRN04742

ASSEMBLY INSTRUCTIONS

CustomerService

Tel1.800.323.5565

Fax1.310.533.3899

MondaythroughFriday8:30AM‐4:30PM(PST)



SevilleClassics,Inc.

Torrance,CA90501USA

www.sevilleclassics.com



PAGE 1
Step 2: Refer to the picture below. First, tighten the 6 pre-inserted Long Screws (marked “A” in the picture). Next, screw in and tighten the 6 Short Screws (B) into the 6 screw holes on the unit (these screw holes are marked “B” in the picture). Do NOT Resin 3-Tier Tower Model No. FRN04742 ASSEMBLY INSTRUCTIONS over tighten the screws. How to Fold the Tower (If Needed): First, fully loosen and remove all 6 Short Screws (marked “B” in the picture above) from the unit.
PAGE 2
READ AND SAVE THESE INSTRUCTIONS Please Note: 1) Do NOT place the unit vertically when unfolding as this may result in the unit CAUTION 1) Do NOT over tighten the screws. Doing so may damage the unit. suddenly unfolding and pinching your fingers. 2) Do NOT place the unit in high temperature area or near appliances that emit large 2) Find a flat surface or floor to assemble the unit. Using an uneven surface or floor to amount of heat.