Use and Care Manual

Parts List
B. Top poles (8)
(Plasc cap on end)
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
[phone] or send an email to [e-mail]
1
D. Shelves (8)
F. Rod bracket (4)
G. Expandable rods (2)
H. U-clips (4)
E. Top shelves (2)
A. Boom poles (8)
(Threaded end)
C. Slip sleeves (48)
I. Screws (4)
J. Feet (8)
K. Liners (8)
L. Nylon Straps (2)
M. Drywall screws (4)
N. Wood screws (4)
Required Tools
O. Wall anchor (4)
Phillips Screwdriver
Power drill
Wall Strap Installaon
STEP 1.
Loop the NYLON STRAPS (L)
around the side of top-shelf
nearest to the wall.
Use 1 per tower.
STEP 2.
Pull the NYLON STRAPS (L)
against the wall and mark
holes where you'd like to
install your ANCHORS (O) or
SCREWS (M, N).
TIP!
Use a stud nder to deter-
mine if you are installing into
drywall or wood.
FOR DRYWALL
Drill a hole in the wall at the
marked point roughly the
depth of the ANCHOR (O).
Screw the ANCHOR (O) into
hole unl ush.
Screw DRYWALL SCREW (M)
into ANCHOR (O) unl snug.
FOR WOOD STUDS
Drill a pilot hole into the wall
at the marked point.
Screw WOOD SCREWS (N)
into holes unl ush.
IMPORTANT
Installing wall straps is not necessary, but it is highly recommended.