Full Product Manual

ManualsBrandsSeville Classics ManualsDesksWalnut Mobile Laptop Sit and Stand Desk with Tilting Tabletop

Seville Classics

Torrance, CA 90501 USA

www.sevilleclassics.com

WEB162_02232017

Tilting Mobile Laptop Desk Cart

Model #: WEB344, WEB361

Thank you for choosing Seville Classics! We hope that you enjoy your new desk cart.

Please read through this user guide for parts list, assembly instructions, frequently asked

questions and further contact information.

Summary of content (6 pages)

PAGE 1
Tilting Mobile Laptop Desk Cart Model #: WEB344, WEB361 Thank you for choosing Seville Classics! We hope that you enjoy your new desk cart. Please read through this user guide for parts list, assembly instructions, frequently asked questions and further contact information. Seville Classics Torrance, CA 90501 USA www.sevilleclassics.
PAGE 2
Parts List A. Base B. T-bar C. Top D. Casters (2) E. Locking casters (2) F. Allen wrench G. Tension knob H. Top screws (4) I. Base screws (4) J. Nuts (4) K. Washers (4) L. 12 mm wrench M. 11 mm wrench Please make sure you have all the parts on this list. If you’re missing parts, contact us for replacements at (800) 323-5565 or send an email to Support@SevilleClassics.com Seville Classics Torrance, CA 90501 USA www.sevilleclassics.
PAGE 3
Assembly Step 1. Assemble Base Tool required: 12 mm wrench (L) Screw the stem of the casters (D) into the base (A) by hand. Install the locking casters (E) on the open end of the base. Tighten until snug with 12 mm wrench (L). Step 2. Install T-Bar to Base Tools required: Allen key (K), 11 mm wrench (M) Line up the bottom holes on T-bar (B) with the four holes in the center of the base. IMPORTANT: Align arrows on the T-bar and base. Be sure the hole for the tension knob (G) is on the right side.
PAGE 4
Step 3. Install Top to T-Bar Tool required: Allen key (K) Line up the bottom holes on T-bar (B) with the four holes on the back of the top (C) so that the curved side of the desk faces the base opening. Affix top to T-bar with top screws (H) and the Allen key (F). Step 4. Tilt the Top To adjust the angle of the top, locate the two latches on either side of the T-bar. Pull both latches down towards the floor to unlock the tilt function. Adjust the top to your desired angle.
PAGE 5
Use Instructions 1. 2. 3. 4. 5. Move desk into desired position and lock casters to prevent movement. Turn the tension knob counter-clockwise to unlock height adjustment. Place hands on both sides of the top and pull up to lift; press down to lower the height. Turn tension knob clockwise until snug to secure the table height. Pull down tabs on both ends of the T-bar to unlock tilting function. Tilt to the desired angle. Press up on tabs at both ends of the T-bar to lock the desk.
PAGE 6