User's Manual

Please refer to the programming manual included in CD.

FCC Information

This device complies with part 15 of the FCC Results. Operation is subject to

the following two conditions:

(1) This Device may not cause harmful interface, and

(2) This device must accept any interference received, including

interference that may cause undesired operation.

Note

This equipment has been tested and found to comply with the limits for

CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instuctions, may cause harmful interference

to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try correct the

interference by one or more of the following measures:

1.1. Reorient or relocate the receiving antenna.

1.2. Increase the separation between the equipment and receiver.

1.3. Connect the equipment into an outlet on a circuit different from

that to which receiver is connected.

1.4. Consult the dealer or experienced radio/TV technician for help.

WARNING

Changes or modifications not expressly approved by the manufacturer

could void the user's authority to operate the equipment.

ǁCertification

7. Setting up the software

CAUTION

Antenna shall be mounted in such a manner to minimize the potential for

human contact during normal operation. The antenna should not be contacted

during operation to avoid the possibility of exceeding the FCC radio frequency

exposure limit.