User`s manual

FlexWATCH User Manual Part 3
4029 43 INTPLUS
Multiplexer, Access control box, X10 Protocol, z256 protocol, etc. by RS-232 or RS-485(422) communication.
You can use By-Pass, X10, and Z256 in Serial Output Mode.
4.1.3. Transparent Mode
If you use Transparent Mode, you can use 2 FlexWATCH® servers to relay the signal from one UART
device to another UART device. It is like direct communication between two UART devices. .
z Line Mode: Communication protocol
z Baud Rate: Communication rate
z Data Bit: Data bit size
z Stop Bit: Stop bit size
z Parity Bit: Parity bit type
z Network Protocol: Network Protocol type for data transmission
z Peer IP: IP of the other connected FlexWATCH server
z Network Port: Network Port number to be used
z Data Start Pattern: Data Start pattern selection. If you don’t want to use, uncheck it.
z Data Size: Data size to be transmitted. If you don’t use, do not enter a value.
4.1.4. PTZ Mode
PTZ (Pan/Tilt/Zoom) device connected to the server can be controlled through either standard web
browser or specific application program over IP network.