User`s manual

FlexWATCH User Manual Part 3
4029 48 INTPLUS
z Default Video Format: You can select NTSC or PAL for your camera attached to
FlexWATCH® Server.
z Video with UART sensor Data: If you check Enable, UART sensor Data will be sent with its
video data.
z Video with user defined message: If you check Enable, user defined message will be sent
with its video data.
z Video with PPP status: If you check Enable, PPP status will be sent with its video data.
z Video with camera name: If you check Enable, camera name will be sent with its video data.
z Video with server name: If you check Enable, server name will be sent with its video data.
z Video with IP address: If you check Enable, IP address will be sent with its video data.
z Time Stamp: Time Stamp will be encoded with video data.
z Image Size: You can select Image Size which applies to all channels.
4 types of Image Sizes as below:
Video Format Full Large Normal Small
NTSC 704 * 480 704 * 240 352 * 240 176 * 112
PAL 704 * 576 704 * 288 352 * 288 176 * 144
z Frame Rate Control: You can select Frame Rate in FPS which applies to all channels. Thus,
you can control server traffic by this parameter.
z Encoding Standard: You can select either M-JPEG or MPEG-4 which applies to all channels.
) M-JPEG: each video frame or interlaced field of a digital video sequence is separately compressed
as a JPEG image. Thus it requires more bandwidth than MPEG-4. However, the quality of a still image
is better than MPEG-4.
) MPEG4: It consists of I-Frame (standard frame) and P-Frame (difference between pictures). Thus it