User`s manual

FlexWATCH User Manual Part 3
4029 52 INTPLUS
z Default Video Format: You can select NTSC or PAL for your camera attached to
FlexWATCH® Server.
z Video with UART sensor data: If you check Enable, UART sensor Data will be sent with its
video data.
z Video with user defined message: If you check Enable, user defined message will be sent
with its video data. .
z Video with PPP status: If you check Enable, PPP status will be sent in video data header.
z Video with camera name: If you check Enable, camera name will be sent with its video data.
z Video with server name: If you check Enable, server name will be sent with its video data.
z Video with IP address: If you check Enable, IP address will be sent in its video data header.
z Frame Rate Control: You can select Frame Rate in FPS which applies to all channels. Thus,
you can control server traffic by this parameter. It applies to both Primary Stream and
Secondary Stream.
z Image Size: You can select Image Size for each Stream.
9 4 types of Image Sizes as below :
Full Large Normal Small
NTSC 704 * 480 704 * 240 352 * 240 176 * 112
PAL 704 * 576 704 * 288 352 * 288 176 * 144
z Encoding Format: You can select either M-JPEG or MPEG-4 for Primary Stream and
Secondary Stream.