User`s manual

FlexWATCH User Manual Part 2
M4028 21 INTPLUS
Not Saving
All the changes will not be stored in Flash Memory.
Notice) If you choose “Not Saving”, all the adjusted settings will not
be saved, Therefore, after rebooting, new change won’t be
applied.
4. Check out if your PPPoE setup is correctly applied; please connect FlexWATCH
directly to xDSL modem.
Notice) No multiple PPPoE setting is supported.
2.4. Network configuration through Hyper Terminal mode
Microsoft Windows provides Terminal emulation program, named Hyper Terminal. For
HyperTerminal connection, Power, RS-232 Cable and LAN cable must be connected to FlexWATCH
server with user’s PC. LAN cable is to run Web browser after configuration using HyperTerminal. You
can continue below configuration after Network setting, and the next process will be same as using
Installation Wizard Program.
2.4.1. Hyper Terminal Installation Wizard Program
1. Link up with the provided serial cable between COM port at FlexWATCH server and
COM1 or COM2 at user’s PC.
2. Run Hyper Terminal Program on user’s PC.
Window start
Æ All Programs Æ Accessories Æ Communications Æ Hyper Terminal
Figure 21 Hyper Terminal Program Location
3. If Hyper Terminal window come up as below, input HyperTerminal name (ex.
FlexWATCH) and press ‘OK’ button.