Instructions / Assembly

Gusset Brace Products
Assembly Instructions
Mailing Address: Phone: 844-SEYMOUR Shipping Address:
PO Box 1674 FAX: [phone] S Country Club Rd
Warsaw, IN 46581-1674 www.SeymourMidwest.com
Warsaw, IN 46580
Gusset Brace Instructions:
1. Slide slotted handle or threaded handle adapter over the center
hole on the aluminum frame as shown in second photo.
2. Position one gusset on bottom of handle/adapter, and the other
gusset on top of the handle/adapter as shown in third photo.
3. Insert the two longest bolts through the top gusset, the
handle/adapter and the bottom gusset. Insert the two shorter bolts
through the two remaining holes on the frame.
4. Tighten all nuts, being careful not to over-tighten. Over-tightening
hardware may result in crushing the handle, thereby compromising
its strength.
Tools Needed for Assembly:
- 7/16” wrench (two)
FULL WARRANTY
All Midwest Rake products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
PK90081
2/3/14
Shown with threaded handle adapter
Shown with aluminum handle